ULMIA GmbH, D-88515 Langenenslingen, Altheimer Str.1

Product-overview | Company | Contact | Downloads | Imprint
   

ULMIA-Planes               1 | 2 | 3 | 4


(back to top

Datasheet

ULMIA scrub plane
as per DIN 7310, plane iron as per DIN 5146. With white beech or lignum vitae sole.

  • Length of plane body 240 mm

  • Width of plane body 49 mm

  • Cutting angle 45°

  • Width of plane iron 33 mm

  • Length of plane iron 180 mm

  • Plane iron bevel angle 25°
Application: Processing of very rough, uneven or contaminated surfaces in preparation for smoothing or levelling (rough planing) the surface of rough sawn or bowed boards.


(back to top)

Datasheet

ULMIA bench plane 
as per DIN 7311, plane iron as per DIN 5145. With white beech or lignum vitae sole.

  • Length of plane body 240 mm

  • Width of plane body 64 mm

  • Cutting angle 45°

  • Width of plane iron 48 mm

  • Length of plane iron 190 mm

  • Plane iron bevel angle 25°
Application: For initial processing of rough sawn or scrub planed surfaces (finishing). Particularly suitable for trimming warped, rough boards at an incline to the grain and also for shaving cross-grained wood. 


(back to top)

Datasheet

ULMIA jointer plane
as per DIN 7218, plane iron as per DIN 5145. With white beech or lignum vitae sole.

  • Length of plane body 600 mm

  • Width of plane body 80 mm

  • Cutting angle 45°

  • Width of plane iron 60 mm

  • Length of plane iron 190 mm

  • Plane iron bevel angle 25°
Application: For finishing and level planing surfaces, joints and straight edges. Particularly suitable for processing large workpieces with long surfaces and for shaving and jointing.


(back to top)

Datasheet

ULMIA short jointer plane
as per DIN 7218, plane iron as per DIN 5145. With white beech sole.

  • Length of plane body 480 mm

  • Width of plane body 74 mm

  • Cutting angle 49°

  • Width of plane iron 54 mm

  • Length of plane iron 190 mm

  • Plane iron bevel angle 25°
Application: For trimming and level planing of surfaces, joints and straight edges. Particularly suitable for processing large workpieces with long surface areas, and for shaving and jointing. Its particular feature is a cutting angle of 49°, which lends the short jointer plane characteristics similar to a very long smoothing plane.


(back to top)

Datasheet

ULMIA jack plane
as per DIN 7219,plane iron as per DIN 5145.With white beech or lignum vitae sole.

  • Length of plane body 240 mm

  • Width of plane body 64 mm

  • Cutting angle 45°

  • Width of plane iron 48 mm

  • Length of plane iron 190 mm

  • Plane iron bevel angle 25°

Application: For levelling and smoothing finished surfaces along and also at an incline to the grain. Application similar to the jointer plain, but on smaller workpieces.